Pneumatic Finger Trainer
Pneumatic Finger Trainer

Pneumatic Finger Trainer

Product Detail

Pneumatic Finger Trainer

Pneumatic Finger Trainer


1. 4 working modes are available:

(1) Manual mode starts to work

Press the "Working Mode" button, select "Manual Mode", and press "√" after the selection.

Next, you need to select a finger, choose which finger to start treatment, and press the button of the finger, the button light and the treatment status below

It will light up accordingly. After completing the parameter configuration, click the start button to start the treatment.

(2) Automatic mode starts to work

Press the "Working Mode" button, select "Auto Mode", and press "√" after the selection is complete.

After the parameter configuration is completed, there is no need to select a finger, click the start button to start the treatment.

The states are as follows: little finger - ring finger - middle finger - index finger - thumb, which will automatically expand and contract in sequence.

(3) The simulated catch mode starts to work

Press the "Working Mode" button, select "Simulate Ball Catch", and press "√" after the selection is complete. After the parameter configuration is completed, there is no need to select fingers, all fingers can be stretched and contracted at the same time to simulate catching the ball, and the treatment can be started by clicking the start button.

(4) The pointing mode starts to work

Press the "Working Mode" button, select "Pointing Mode", and press "√" after the selection is complete. After the parameter configuration is completed, there is no need to select a finger, click start to start the treatment.

Fingering mode is to stretch and contract the thumb, index finger and middle finger at the same time.


If you want to pause the treatment process, press the "pause button", after reaching the number of cycles, or press the switch control button "end button", the treatment ends.


2. Precautions

1. When the work is over, the power switch must be turned off, otherwise the machine is still in a live state.

2. When working, you should pay attention to whether the instrument has abnormal noise and obvious air leakage (the air pump works frequently). If so, please contact the manufacturer or special service provider as soon as possible.

3. The operation mode cannot be switched during operation.

4. When the instrument is used for the first time, connect the accessories completely. In the state of not wearing it, start the device for about 1 minute to test run it for about 1 minute to confirm whether the airbag hose and other parts are working normally and safely.

5. When using the instrument for the first time, please use it under the guidance of a doctor or professional. A doctor or professional will personalize the instrument for the patient's own condition, including training parameters.

6. For the first use of the patient, it is recommended that the continuous treatment time be controlled within 30 minutes, and the interval between two uses should be at least 45 minutes. Observe the symptoms of the affected area, and use it so as not to increase the burden on the affected area.


Inquiry Now
Name: *
Mobile:
E-mail: *
Message: *
Verification code: *
  
Other products
Hot products